Firmware Release History

 

Model: U320 SCSI to SATA-II 4 CHL. (i80321/80219) (6314)

 

 

Version

Boot Code

Release Date (MM/DD/YYYY)

Notes

1.46-090106

1.46-090106

05/08/2009

Update from 1.36 and earlier, Ethernet configuration must be saved again.

1.      Added display of IU status.

2.      Fixed NTP error after 2009.

3.      Fixed Solaris 10 inquiry page 0x83 issue.

4.      Fixed Solaris LBA overflow issue.

5.      Fixed ATTO U320 SCSI issue.

6.      Improved SNMP agent request overflow issue.

7.      Exclude super password via TELNET for security reason.

8.      Modified the LOGIN event from ERROR to WARNING.

1.45-080314

1.45-080314

04/25/2008

Update from 1.36 and earlier, Ethernet configuration must be saved again.

1.      Fixed RAID level 1 and 0+1 issue.

2.      Added MAC over Two TB for SCSI model.

3.      Added MAID function. (Spin Down Idle HDD).

4.      Added Off-Line RaidSet for on-line roam member disks to another subsystem.

5.      Added auto hot spare support (across power cycle).

6.      Added support MTRON SSD.

7.      Fixed Seagate 750G/500G SATA disk timeout issue.

8.      Fixed U320 SCSI bus power cycle bus reset issue.

9.      Fixed for SANYO DVR.

10. Fixed WD 1TB drive detection issue.

11. Fixed IE7 update firmware problem under Vista.

12. Fixed U320 SCSI separate in-band device, API cannot detect.

13. Fixed to avoid ‘CHECK CONDITION’.

14. Modify command length to fix Adaptec U320 card dump issue in Linux.

1.42-061103

1.42-061013

12/04/2006

Update from 1.36 and earlier, Ethernet configuration must be saved again.

1.      Added HDD timeout option (12, 17, 22, 27 and 32).

2.      Change bad block generation to compatible with Seagate.

3.      Change the Voltage high limit to 5.4V for 5V.

1.41-060524

1.41-060711

08/18/2006

Update from 1.36 and earlier, Ethernet configuration must be saved again.

1.      Support 256 MB on board cache.

2.      Added multiple volume check at one time (HTTP only).

3.      Added SCRUB bad block and REPAIR parity function.

4.      Added Event and warning if incomplete RAID Set discovered.

5.      Added completion aborted and stopped events for migration, rebuilding and initialization.

6.      Fixed Hitachi HD issue (Raid locked up).

7.      Fixed WD4000YR detect problem (power on/off).

8.      The LBA address is logged for reference when Power loss during migration, rebuilding and initialization.

1.39-051206

1.39-051206

02/09/2006

Update from 1.36 and earlier, Ethernet configuration must be saved again.

1.      Support Processor i80219.

2.      Support RAID 6 function.

3.      Support Over 2TB.

4.      Add Stagger power on control function.

5.      Added mail SMTP port settable.

6.      Add SMART status polling settable.

7.      Add 12/16CDB Selection.

8.      Fixed Host potential error in U320 mode.

9.      Display SMART status in drive status.

1.36-050610

1.36-050428

06/17/2005

1.      Initial release.