Firmware Release History

 

Model: U320 SCSI to EIDE 8 CHL. (i80321) (6420)

 

 

Version

Boot Code

Release Date

Notes

1.42-061103

1.42-061013

01/10/2007

Update from 1.36 and earlier, Ethernet configuration must be saved again.

1.      Added multiple volume check at one time (HTTP only).

2.      Added SCRUB bad block and REPAIR parity function.

3.      Added Event and warning if incomplete RAID Set discovered.

4.      Added completion aborted and stopped events for migration, rebuilding and initialization.

5.      New rescue mode.

6.      Added new LSI chip support (A3).

7.      Added HDD timeout option (12, 17, 22, 27 and 32).

8.      The LBA address is logged for reference when Power loss during migration, rebuilding and initialization.

9.      Change the Voltage high limit to 5.4V for 5V.

1.39-060308

1.39-051206

04/07/2006

Update from 1.36 and earlier, Ethernet configuration must be saved again.

1.      Added Stagger power on control function.

2.      Added RAID 1(1+0) with initialization function.

3.      Fixed Ethernet problem (Browser and Telnet can not connect).

4.      Fixed Hitachi 500G HDS725050KLAT80 issue.

5.      Display SMART status in drive status.

6.      Mail SMTP port settable.

1.38-051123

1.37-050902

12/12/2005

Update from 1.36 and earlier, Ethernet configuration must be saved again.

1.      Add Http and Telnet disable function.

2.      Add NTP function.

3.      Support Pre-read function.

4.      Fixed Hitachi 500G issue.

5.      Fixed LSI 1030T channel B potential issue.

6.      Login record in the event log (http / telnet / serial).

1.36-050428

1.35-050303

05/13/2005

1.      Add 5 seconds delay for battery backup support.

2.      Support 16/12 bytes CDB and Windows large block.

3.      Add ‘Timeout’ option.

4.      Add ‘Retry times’ option.

5.      Add ‘Error statistic’ report.

6.      Support WD RE model special function.

7.      TCP/IP timeout change to 3 minutes.

8.      Send RST to client if TCP connection over 3 minutes.

9.      Fixed disk geometry of mode sense parameter for Solaris.

10. Use NEW_SMART function for disks.

11. Improve random access performance.

12. SNMP parameter can be modify for, sysContact.0, sysLocation.0 and sysName.0

1.33-040928

1.33-040928

10/06/2004

1.      Add telnet support.

2.      Fixed RAID 5 fail two disk issue.

3.      Fixed SUN SPARC on-board SCSI issue.

4.      Modify BOOT module.

1.31-040527

1.33-040928

05/28/2004

1.      Add QAS setting for U320.

2.      Fixed ATTO U320 SCSI problem.

3.      Fixed Mac LUN problem.

4.      Fixed DHCP problem.

1.30-040324

NA

03/25/2004

1.      Initial release.